Diffusion welding is a solid-state metal joining technique using heat and pressure to create strong bonds between metal parts. Discover how it works, why a vacuum is used, which metals can be joined, and the key factors affecting joint quality. Learn about its applications in multilayer components and heat exchangers.
Diffusion welding is a method of joining metals in the solid state. The parts are heated and pressed together so that atoms can move across the interface. This technique makes it possible, for example, to join a stack of metal plates while preserving channels that have been pre-formed in each plate.
Even seemingly smooth surfaces initially touch only at the peaks of microscopic irregularities. When heated, metal deforms more easily, and under pressure, these protrusions flatten out. The area of direct contact increases, and the gaps between surfaces are reduced.
The parts are held at specified temperature and pressure. During this time, atoms migrate across the boundary where the surfaces are already in close contact. As the process continues, the bonded regions expand, and the remaining micropores shrink. Gradually, a strong metallic bond forms between the parts.
When metal is heated in air, it oxidizes. The oxide film prevents tight contact between surfaces, so air is evacuated from the chamber. Depending on the alloy and technology, an inert gas atmosphere can be used instead of a vacuum.
To learn about the role of vacuum in another metal joining method, read the article "Electron Beam Welding: Why Metals Are Welded in a Vacuum".
In a typical setup, a vacuum furnace heats the parts, and a hydraulic press applies pressure through tooling. The process mode is selected according to the alloy and the geometry of the parts. Temperature determines the rate of diffusion, pressure ensures tight contact, and hold time allows the joint to develop across the interface. Excessive pressure can deform thin walls and narrow internal channels.
Diffusion welding is used for titanium alloys, stainless steel, as well as nickel-, copper-, and aluminum-based alloys. Plates made from a single alloy are usually joined directly. For dissimilar metals, the process mode is selected considering how both materials behave during heating and how they interact at the joint interface.
For example, directly joining titanium to steel may result in brittle iron-titanium compounds at the interface. To minimize their formation, a thin layer of another metal is placed between the parts. This interlayer is chosen so that it forms a strong bond with both parts when heated.
Before welding, surfaces are leveled, finished to the required roughness, and degreased. Waviness and deep scratches leave gaps even under load. Residual oil and persistent oxide films prevent metals from coming into close contact.
If pressure is uneven or hold time is too short, pores and unjoined areas may remain in the joint. Such defects reduce the area that can bear load. If gaps form a continuous path through the joint, the connection may leak fluids or gases.
Compact heat exchangers are assembled from metal plates with grooves. During welding, the plates are joined at flat areas, while the grooves inside the stack form enclosed channels. Adjacent channels may carry heat transfer fluids under high pressure, so the quality of the joint determines whether the flows remain separated.
The same principle is used to make lightweight honeycomb structures from thin metal foil. Here, it is important to bond the layers while preserving the shape of the cells.
With brazing, the gap is filled with molten filler metal. With diffusion welding of same-alloy plates, the bond is formed directly between the plates themselves. This method is chosen when a strong bond is needed over the entire contact area. When selecting the process, consider the costs of precise surface preparation, tooling for even pressure, and extended hold time in the furnace.
Diffusion welding is suitable for multilayer components where it is necessary to preserve the shape of internal channels and achieve a strong bond across the full contact area. When choosing this method, it is important to ensure the part can withstand heating and uniform pressure. Before mass production, test samples are checked for joint strength, and for parts with channels, for leak tightness as well.